Belkin F5D8051 User Manual page 36

Troubleshooting
Changing the wireless channel – Depending on local wireless
traffic and interference, switching the wireless channel of your
network can improve performance and reliability. The default
channel the router is shipped with is channel 6. You may choose
from several other channels depending on your region; see your
router's (or access point's) user manual for instructions on how to
choose other channels.
Limiting the wireless transmit rate – Limiting the wireless
transmit rate can help improve the maximum wireless range, and
connection stability. Most wireless cards have the ability to limit
the transmission rate. To change this property, go to the Windows
Control Panel, open "Network Connections" and double-click on
your Adapter's connection. In the "Properties" dialog, select the
"Configure" button on the "General" tab (Windows 98 users will
have to select the USB Network Adapter in the list box and then
click "Properties"), then choose the "Advanced" tab and select the
rate property. Wireless client cards are usually set to automatically
adjust the wireless transmit rate for you, but doing so can cause
periodic disconnects when the wireless signal is too weak; as a
rule, slower transmission rates are more stable. Experiment with
different connection rates until you find the best one for your
environment; note that all available transmission rates should be
acceptable for browsing the Internet. For more assistance, see
your wireless card's literature. If issues persist even at close range,
please contact Belkin Technical Support.
Why are there two wireless utilities in my system tray?
Which one do I use?
There are several features and advantages from using the Belkin
Wireless Networking Utility over the Windows XP Wireless
Zero Configuration utility. We offer a site survey, detailed link
information, and adapter diagnosis, to name a few.
It's essential to know which utility is managing your Adapter. We
recommend using the Belkin Wireless Networking Utility. To use the
Belkin Wireless Networking Utility, follow the steps below:
Step 1
Right-click on the network status icon in the system tray and
select the "Status" tab.
Step 2
From the "Status" tab, uncheck the "Use Windows to
configure my wireless network settings" box. Once the box is
unchecked, click the "Close" button to close the window.
You are now using the Belkin Wireless Networking Utility to
configure the Adapter.
34 34