Table of Contents
Advertisement
USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
SWING
Press the SWING button until the SWING indicator light is illuminated on the
control panel. The louvers will begin to move left to right automatically.
Vertical Air Flow - You can manually adjust the louvers to change vertical air flow.
COOL
Press the COOL button until the COOL indicator light is illuminated on the control panel. This activates
evaporative cooling. The water pump will operate and you will feel the cooler air after the Honeycomb
Cooling Media is completely wet.
Note: When the COOL indicator light is switched OFF, the unit can still function in a fan only mode
(without evaporative cooling).
TIMER
Press the TIMER button until the desired time duration setting is selected. When the set time has
passed, the unit will automatically turn off (unit remains in Standby mode until power cord is unplugged
from electrical socket). The TIMER function allows you to program the unit for up to 7.5 hours of use.
REMOTE CONTROL
ON/OFF
MODE
TIMER
SWING
SPEED
Note:
Open the battery compartment at the back of the remote control and insert a AAA (2 x 1.5V) battery
inside. Care must be taken to insert the batteries according to the correct polarity (+ / –) markings
shown inside the battery compartment.
Always point the remote control signal transmitter towards the unit when operating. Make sure that
the signal path is not obstructed.
Remove the batteries if the unit is not going to be used for an extended period of time.
Do not drop the remote control.
Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
Do not mix old and new batteries.
Exhausted batteries are to be removed from the product.
COOLER LOCATION
Make sure to position the air cooler correctly before you set up and start using the product. Please refer
to the COOLER LOCATION section of the separate Safety & Maintenance Guide.
2
Power
: ON / OFF
Speed
: Low / Medium / High / Sleep
Mode
: Evaporative Cooling On / Off
Swing
: Controls the motion of the louvers
Timer
: Controls timer function for automatic off
LOUVER
MOVEMENT
Advertisement
Table of Contents
