Setting Individual Weekdays - Worcester DT20RF Instruction Manual

1
2
3 3
4
5 5
6
3rd CH OFF
7
FITTING & OPERATING INSTRUCTIONS FOR WORCESTER BOSCH
DT20RF PROGRAMMER
8-716-106-659 issue a (08.04) UK
RECEIVER
SETTING PROGRAMS

Setting individual weekdays:

Note: if you do not require individual
weekday times, then press ‘set?’ until
‘SET’ SAT-SUN are displayed and
continue on the next page.
If you do not wish to change the
settings for the day displayed, then
press 'set?' until the first day you
want to change is displayed
Setting CH individual weekdays:
1 Press 'OK' to select weekday
2 Press 'OK' to select CH
Note: speed up the display by holding
down the ‘+’ or ‘-’ buttons.
3 Press ‘+’ or ‘-’ to change the ON
time
4 Press ‘set?’ to set the ON time and
select the OFF time
5 Press ‘+’ or ‘-’ to change the OFF
time
6 Press ‘set?’ to set the OFF time and
select the next ON time
Repeat operations 3 to 6 to set the
2nd and 3rd CH ON/OFF times.
Note: after pressing ‘set?’ for the 3rd
CH OFF time the display shows ‘SET’
HW for that weekday
Setting HW individual weekdays:
7 Press ‘OK’ to select the first ON time
Repeat operations 3 to 6 to set the
1st, 2nd and 3rd HW ON/OFF times.
Note: after pressing ‘set?’ for the 3rd
HW OFF time ‘SET’ and the next
weekday are displayed shown . . . after
completing the steps above for FRI
the display shows ‘SET’ SAT SUN
(see next page)
SETTING PROGRAMS
11
RECEIVER