NEC NP600 User Manual page 71

Settng ID to the Projector [CONTROL ID]
(Avalable only when the optonal remote control NP0RC s used)
You can operate multiple projectors separately and independently with the single remote control that has the CONTROL
ID function. If you assign the same ID to all the projectors, you can conveniently operate all the projectors together
using the single remote control. To do so, you have to assign an ID number to each projector.
CONTROL ID NUMBER .......Select a number from 1 to 254 you wish to assign to your projector.
CONTROL ID .......................Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID set-
ID DISPLAY ........................This option turns on or off the ID number which is displayed when the ID SET button on the remote
NOTE:
• Selecting [ON] for [CONTROL ID] will make the remote control supplied with the projector inoperable. The buttons on the projector
cabinet can be used. Neither can you operate the projector by using the optional remote control NP01RC that does not has the
CONTROL ID function.
• Your setting will not be affected even when [RESET] is done from the menu.
• Pressing and holding the ENTER button on the projector cabinet for 10 seconds will display the menu for canceling the Control
ID.
Assgnng or Changng the Control ID
1. Turn on the projector.
2. Press the ID SET button on the remote control (NP02RC).
The CONTROL ID screen will be displayed.
If the projector can be operated with the current remote control ID, the [ACTIVE] will be displayed. If the projector
cannot be operated with the current remote control ID, the [INACTIVE] will be displayed. To operate the inactive
projector, assign the control ID used for the projector by using the following procedure (Step 3).
3. Press one of numeric keypad buttons while pressing and holding the ID SET button on the remote control
(NP02RC).
Example:
To assign "3", press the "3" button on the remote control.
No ID means that all the projectors can be operated together with a single remote
control. To set "No ID", enter "000" or press the CLEAR button.
TIP: The range of IDs is from 1 to 254.
4. Release the ID SET button.
The updated CONTROL ID screen will be displayed.
NOTE: The IDs can be cleared in a few days after the batteries are run down or removed.
ting.
control is pressed.
6
5. Using On-Screen Menu
OFF
POWER
COMPUTER
1 2 3
VIDEO S-VIDEO COMPONENT
VIEWER NETWORK
1 2
4 5
7 8
0
ID
MENU
ENTER
L-CLICK
VOLUME MAGNIFY
PICTURE LAMP MODE
AV-MUTE 3D REFORM
FOCUS
ID SET LENS SHIFT /ZOOM
ID
OFF
POWER
COMPUTER
1 2 3
VIDEO S-VIDEO COMPONENT
VIEWER NETWORK
1 2
4 5
7 8
0
ID
MENU
ENTER
L-CLICK
VOLUME MAGNIFY
PICTURE LAMP MODE
AV-MUTE 3D REFORM
FOCUS
ID SET LENS SHIFT /ZOOM
ID
ON
AUTO ADJ.
HDMI
PIP
3
6
9
CLEAR
EXIT
R-CLICK
PAGE
UP
DOWN
ASPECT
FREEZE
HELP
ON
AUTO ADJ.
HDMI
PIP
3
6
9
CLEAR
EXIT
R-CLICK
PAGE
UP
DOWN
ASPECT
FREEZE
HELP