Terminal Block Connector - QSC CMX 300V User Manual

Terminal Block Connector

The terminal block connector requires the following assembly.
1. Strip the wires to 7 ~ 8 mm.
2. Insert the wires into the male part of the connector according to the Mode you are using. See below.
3. Use a fl at-tip screwdriver to secure the wires. Tighten the screws to 6 in.-lbs.
4. Insert the plug into the receptacle on the amplifi er.
5. Use a fl at-tip screwdriver to secure the connector. Tighten the screws to 6 in.-lbs.
Stereo and Parallel Mode: Wire as shown by loudspeaker symbols 1 and 2, and the solid wires in
Bridge Mode: Wire as shown by Bridge Mono loudspeaker symbol, and the dashed wires in
– Figure 30 –
Terminal Block Connector Wiring
Wire range
Solid wire (AWG)
Stranded wire (AWG/mm 2 )
Torque (lb.-in.)
Wire strip length
– Table 3 –
(Figure
(Figure 30).
UL IEC
- 6 mm
28 – 10 -
28 – 10 -
6 -
7 – 8 mm -
15
30).
2
ENG