Optional Accessories; Replacing Carbon Brushes - Makita JN3200 Instruction Manual

When installing ground die, a clearance of 3.5 to 4.0 mm
should be obtained by attaching one or two of the washer
provided, as shown in the figure. Failure to have the
proper clearance will result in vibration during cutting.
(Fig. 10)
CAUTION:
• Secure installing screws carefully when installing. A
loose screw can cause tool breakage during operation.
NOTE:
• The die can be sharpened two times. After two
sharpenings, it should be replaced with new one.

Replacing carbon brushes

Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only
identical carbon brushes. (Fig. 11)
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps. (Fig. 12)
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
• These accessories or attachments are recommended
for use with your Makita tool specified in this manual.
The use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory
or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Die
• Punch
• Hex wrench
• Wrench 50
• Die height adjustment washer
NOTE:
• Some items in the list may be included in the tool
package as standard accessories. They may differ from
country to country.
7