Front Panel Audio Connector: Jaudio1; Front Usb Connector: Jusb1/Jusb2; Clear Cmos Jumper: Jbat1; Agp (Accelerated Graphics Port) Slot - MSI K9MM-V Instruction Manual

Front Panel Audio Connector: JAUDIO1

The front panel audio connector allows you to
connect to the front panel audio and is compliant
®
with Intel Front Panel I/O Connectivity Design
Guide.
MSI Reminds You...
If you do not want to connect to the front audio header, pins 5 & 6, 9 & 10 have to be jumpered in
order to have signal output directed to the rear audio ports. Otherwise, the Line-Out connector on
the back panel will not function.

Front USB Connector: JUSB1/JUSB2

The mainboard provides two standard USB 2.0 pin headers
JUSB1 & JUSB2. USB2.0 technology increases data
transfer rate up to a maximum throughput of 480Mbps,
which is 40 times faster than USB 1.1, and is ideal for
connecting high-speed USB interface peripherals such as
USB HDD, digital cameras, MP3 players, printers, modems, etc.
MSI Reminds You...
Please note that the pins of VCC & GND must be connected correctly or it may cause some
damage

Clear CMOS Jumper: JBAT1

There is a CMOS RAM on board that has a power supply from
external battery to keep the data of system configuration. With the
CMOS RAM, the system can automatically boot OS every time it
is turned on. If you want to clear the system configuration, use the
JBAT1 (Clear CMOS Jumper) to clear data. Follow the instructions in the image to clear the data.
MSI Reminds You...
You can clear CMOS by shorting 2-3 pin while the system is off. Then return to 1-2 pin position.
Avoid clearing the CMOS while the system is on, which will damage the mainboard.

AGP (Accelerated Graphics Port) Slot

The AGP slot allows you to insert the AGP graphics card. AGP is an interface specification
designed for the throughput demands of 3D graphics. It introduces a 66MHz, 32-bit channel for
the graphics controller to directly access main
memory.
(2)AUD_GND
(1)AUD_MIC
10
2
1 9
8
AUD_RET_R
Key
AUD_VCC
HP_ON
AUD_MIC_BIAS
AUD_FPOUT_R
GND
(9)Key,no pin
(10)N.C.
GND
3
2
1
Keep Data
AUD_RET_L(10)
AUD_FPOUT_L(9)
USB0+
USB0-
VCC(1)
VCC(2)
USB1-
USB1+
3 3
2 2
1 1
Clear Data