Installing The Usb Driver; Found New Hardware Wizard: Welcome - NEC MH150 Software Manual

Installing the USB Driver

NOTE
Figure 2-7 Found New Hardware Wizard: Welcome
NEC MH150/MH160 Mobile Handset Administration Tool-Installation and User Guide - Issue 1
The USB driver installation allows the Dual Charger to be the
communication link between the handset and the PC. The two files
needed for the USB driver to function are named slnkusb.sys and
slnkusb.inf. If the Destination Folder had not been changed in step-3,
these files will be located at C:\Program Files\HandsetAdmin\Driver\
Find the USB driver files on the PC.
Step 1
Place the Dual Charger on a flat, horizontal surface. Plug the power
Step 2
supply into the Dual Charger and into an appropriate wall outlet.
Plug the USB cable into the Dual Charger and into an available USB port
Step 3
on the PC.
Power off a NEC MH150 and MH160 Mobile Handset, remove the
Step 4
Battery Pack (optional), and place the handset in the Charger. If properly
seated, the handset automatically powers up in USB mode and the
handset screen displays a USB Mode on indication.
If the handset is not properly seated in the Dual Charger, the USB connection will not
be made and the Battery Pack will begin charging, and the handset screen displays
a Charging... indication. If this occurs, reseat the handset, check the connections on
the USB cable, and/or remove the Battery Pack and try again.
Microsoft Windows will start the Found New Hardware Wizard. There is
Step 5
no need to connect to Windows Update, so select No, not this time and
click Next.
Handset Administration Tool Installation 2-7