Before Starting 10 - O.S. engine MAX-15 Owner's Instruction Manual

Remove the two cover-plate screws which secure
1.
the needle-valve assembly bracket, then carefully
remove the two screws by which the needle-valve
unit is attached to the bracket.
2. Rotate the needle-valve unit through 90˚ and re-
attach it to the bracket in the required position.
Note:
As self-tapping screws are used for unit
attachment, screw them in carefully so that screw
threads match those of the unit body precisely.
3.
Finally, secure the complete assembly to rear cover
plate as before.
Needle Valve unit
Cover plate fitting holes
Needle-Valve
Assembly Bracket
Needle Valve unit attachment screws
Vertical position
Horizontal position
BEFORE STARTING
Tools, accessories, etc.
The following items are necessary for operating the
engine.
1 Fuel
Model glowplug engine fuel of good quality, preferably
containing a small percentage of nitromethane. (See
"Advice on selection of fuel, glowplug and propeller")
2 Glowplug
O.S. A3 glowplug is installed in the engine.
3 Propeller
Suggested size is 8X4 (15LA-S), 9X6 (25LA-S),11X5
(40LA-S), or 11X6 (46LA-S).
4 Glowplug battery
The power source for heating the glowplug may be
either a large heavy-duty 1.5volt dry cell, or preferably,
a 2-volt rechargeable lead-acid cell (accumulator).
1.5 volt heavy-duty or 2 volt rechargeable
dry battery lead-acid cell (at least 5Ah)
10
If a 2-volt cell is employed,
use a resistance wire, as
shown, to reduce applied
voltage, otherwise the element
will overheat and burn out.