L300 Device Setup - NComputing L130 User Manual

L300 Device Setup

(For L230 and L130 devices, see next section)
The L300 must be connected to the host PC via an Ethernet switch, router, or other network connection. The
L300 has USB ports dedicated for mice and keyboards, as indicated by the mouse and keyboard symbols
below the horizontally oriented USB ports. The vertically oriented USB ports to the left of the audio
connections are for other USB devices.
NOTE: The USB keyboard and mouse ports ONLY support these types of devices. No other types of
USB devices are supported on these ports. The USB keyboard and USB mouse must be directly
connected to these ports and cannot go through a separate USB hub. Peripherals with integrated USB
hubs or combination keyboard/mouse devices are not supported by these ports. Other USB peripherals
can be connected to the vertically oriented ports that are to the left of the audio ports – note that these
generic ports are not active until you have connected to a vSpace session.
Network connection
The L300 device can be configured to use DHCP-assigned network settings, or use static IP settings specified
by the user. To use DHCP-assigned settings, power on the device, then go into the Device Setup, click the
"Network" tab, and select the bullet labeled "DHCP."
L300/L230/L130 User Manual
12