Xm Receiver - Panasonic CQ-RX400U System Upgrade Manualbook

XM Receiver

Connecting XM Receiver
• Connect the optional XM receiver (XMD1000) with
optional Digital Adaptor Cable (XMDPAN110).
• Connect the optional XM Direct 2 (CNP2000UC) with
optional Connection Cable (CNPPAN1).
Getting Started
It is required to sign up to become an XM Satellite Radio
subscriber. After checking your XM Satellite Radio ID,
sign up on the XM's website or by calling them.
1 Check of XM Satellite Radio ID.
• Write down the ID indicated on the lower right of your
XM receiver (XMD1000)/XM Direct 2
• Check the ID shown by tuning your XM Radio to
channel 0. (Refer to "Channel Selection" below.)
RADIO ID display
2 Activate the XM Satellite Radio.
Select either of the below to sign up.
• Web site: http://www.xmradio.com/activation
• Phone number: 1-800-852-9696
Press [SRC] to select the XM Satellite
1
Radio mode.
Press [BAND] to select a band.
2
Notes:
• Connect the optional XM receiver (XMD1000).
To connect the XM receiver (XMD1000), it is required
to use an optional Digital Adaptor Cable (XMDPAN110)
that is produced by XM exclusively for Panasonic
products.
• Connect the optional XM Direct 2 (CNP2000UC).
2
To connect the XM Direct (CNP2000UC), it is required
to use an optional Connection Cable (CNPPAN1) that is
produced by XM exclusively for Panasonic products.
• "RADIO ID" is displayed with channel 0.
• "LOADING" is displayed during the acquisition of audio
data or information.
Select a channel.
3
Channel Selection
[] (TUNE): Preceding channel
[] (TUNE): Next channel
14
CQ-RX400U/CQ-RX200U
XMD 1000 XM Radio ID
L/C 1144XXXXXX XM RADIO ID : XXXXXXXX
(CNP2000UC).
Preset Channel Selection
Press the numeric button [1] to [6].
Notes:
• Because preset memory setting is performed with
Service IDs in each channel, a channel may switch
to another that has been stored under the same
Service IDs when calling up a preset channel.
However, broadcasting contents are the same as
what the stored channel provides.
• Channel selection is not available during the
reception of channel 1 with category ON. To
receive other channels, set the category to OFF or
switch to another category. (
Notes:
• "– – – –" or blank space is displayed when there is no
• "UPDATING" is displayed when channel information is
page 16)
Indicates the satellite receiver is ready.
Channel number
Band
Press [DISP].
Band/channel number/preset
number
(Data reading)
Channel name (Default)
(Data reading)
Artist name
(Data reading)
Song title
(Data reading)
Category name
Clock time
information.
updated.
Preset number
15
CQ-RX400U/CQ-RX200U