The First Wash Cycle; Technical Data; Electrical Connections - Indesit PWDE 81473 W Instructions For Use Manual

Connecting the drain hose
! We advise against the use of hose
extensions; if it is absolutely necessary, the
extension must have the same diameter as
the original hose and must not exceed 150
cm in length.

Electrical connections

Before plugging the appliance into the
electricity socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the
maximum power load of the appliance as
indicated in the Technical data table (see
opposite);
• the power supply voltage falls within the
values indicated in the Technical data table
(see opposite);
• the socket is compatible with the plug of the
washer-dryer. If this is not the case, replace
the socket or the plug.
! The washer-dryer must not be installed
outdoors, even in covered areas. It is
extremely dangerous to leave the appliance
exposed to rain, storms and other weather
conditions.
! When the washer-dryer has been installed, the
electricity socket must remain within easy reach.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
! The power supply cable must only be
replaced by authorised technicians.
Connect the drain
hose, without
bending it, to a drain
duct or a wall drain
situated between 65
and 100 cm from the
floor;
alternatively, placed
it over the edge
of a basin, sink or
tub, fastening the
duct supplied to
the tap (see figure).
The free end of the
hose should not be
underwater.
Warning! The company shall not be held
responsible in the event that these standards
are not observed.

The first wash cycle

Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using
wash cycle number 2
.

Technical data

Model PWDE 81473 W
width 59.5 cm
Dimensions height 85 cm
depth 60 cm
from 1 to 8 kg for wash
programme
Capacity
from 1 to 6 kg for the drying
programme
please refer to the technical
Electrical
connections data plate fixed to the machine
maximum pressure
1 MPa (10 bar)
Water con-
minimum pressure
nections
0.05 MPa (0.5 bar)
drum capacity 62 litres
up to 1400 rotations per
Spin speed
minute
wash: programme 2; tem-
perature 60°C; using a load
of 8 kg.
Energy ra- drying: the smaller load
must be dried by selecting
ted
programmes the "A1" (IRON) dryness le-
according to vel. The load must consist of
regulation 2 sheets, 1 pillowcase and
EN 50229 1 hand towel; the remainder
of the load must be dried by
selecting the "A4" (EXTRA)
dryness level.
This appliance conforms to
the following EC Directives:
- 2004/108/EC (Electroma-
gnetic Compatibility)
- 2006/95/EC (Low Voltage)
- 2002/96/EC
GB
63