National Instruments NI-488.2 User Manual page 62

Chapter 6 Interactive Control Utility
Table 6-1. Syntax for Device-Level Traditional NI-488.2 Calls in Interactive Control (Continued)
Syntax
ibeos v
ibeot v
ibln pad sad
ibloc
ibonl v
ibpad v
ibpct
ibppc v
ibrd count
ibrda count
ibrdf flname
ibrpp
ibrsp
ibsad v
ibstop
ibtmo v
ibtrg
ibwait mask
ibwrt wrtbuf
ibwrta wrtbuf
ibwrtf flname
NI-488.2 User Manual for Windows
Change/disable EOS message
Enable/disable END message
Check for presence of device on the GPIB at
Go to local
Place device online or offline
Change primary address
Pass control
Parallel poll configure
Read data where
count
Read data asynchronously where
Read data to file where
Conduct a parallel poll
Return serial poll byte
Change secondary address
Abort asynchronous operation
Change/disable time limit
Trigger selected device
Wait for selected event where
of mask bit mnemonics, such as
Write data
Write data asynchronously
Write data from a file where
Description
is the bytes to read
is the bytes to read
count
is pathname of file to read
flname
is a hex or decimal integer or a list
mask
ibwait TIMO CMPL
is pathname of file to write
flname
6-6
,
pad sad
www.natinst.com