Erasing Flash - Garmin GMA 347 Installation Manual

Figure 5-7 Wrong Hex File Selected (Selecting System Code for Boot Code Upload)
Selecting the correct Hex file and clicking Open will start the code upload. After the correct Hex file is
selected, Figure 5-8 will open with the title "Erasing Flash...". In approximately 20 seconds the window
displayed in Figure 5-8 will turn into the window displayed in Figure 5-9. The "Uploading Flash..."
window shows the percentage of code uploaded, the time remaining, and the time elapsed
Flash being erased
Figure 5-8 Erasing Flash
Code Upload window after flash has been erased
Figure 5-9 Uploading Flash
If the Cancel button is clicked while the code is being uploaded, Figure 5-10 will warn that a code upload
is in progress. Click No to resume the code upload. Click Yes to cancel the code upload.
Figure 5-10 Canceling a Code Upload
If the code upload is cancelled, Figure 5-11 will show that the code upload failed.
GMA 347 Installation Manual Page 5-7
190-00325-01 Revision A