5.10 Code Upload - Garmin GMA 347 Installation Manual

5.10 Code Upload

To upload code, first select the type of code to be loaded into the unit. SYS is SYSTEM code and BB is
BOOT BLOCK code. If no selection is made by using the mouse to select a radio button and "Upload" is
selected, Figure 5-4 will appear to indicate a selection must be made to specify the code type to be loaded.
Figure 5-4 Radio Button Not Chosen and Upload Selected
After selecting the type of code to load, Figure 5-5 will open for the Hex file of the software to be
selected.
Figure 5-5 File Selection
Select the Hex file to upload and click on Open. If boot code is selected while attempting to do a system
code upload, Figure 5-6 will warn about the possible user error. Clicking cancel will allow the correct
Hex file to be selected.
Figure 5-6 Wrong Hex File Selected (Selecting Boot Code for System Code Upload)
If system code is selected for a boot block upload, Figure 5-7 will warn that the wrong hex file has been
selected.
Page 5-6 GMA 347 Installation Manual
Revision A 190-00325-01