Samsung MX-JS9000 User Manual page 26

Functions
• FLANGER : Creates an effect similar to the
sound of a jet engine revving up and down.
• CHORUS : Creates an effect similar to a singing
chorus.
• WAHWAH : Creates a 'Wah~ Wah~' effect.
• TREMOLO : Repeatedly and rapidly turns the
volume up and down.
• FUZZ : Distorts the original sound to make it
harder and harsher.
• PHASER : Alters the original sound from clear
to dull.
• SLAPBACK : Creates the effect of a slapback
echo following the original sound.
• DJ BEAT OFF : Turns off this function.
| NOTES |
✎ You can control the intensity of the effect with
the FOLDER -, + button.
✎ To cancel an effect, press the effect's button
again.
✎ You can also control the effect using the
EFFECT-, + button on the remote control.
✎ Use the FOLDER -, + button to control the
intensity of the effect that was activated last.
For example, if you activated the WahWah
effect and then the Panning effect, the
FOLDER -, + button will control the Panning
effect.
✎ To control the intensity of the effect you
applied first, press the button of effect that you
applied last to turn it off. Then, you can use the
FOLDER -, + button to control the intensity of
the first effect.
+PANNING Function
Increases the left and right speaker's output in
turn and makes it seem as if the sound is moving
from side to side.
| NOTE |
✎ To apply the PANNING effect to another effect,
press the +PANNING button when the other
effect is active or press another effect button
when the PANNING effect is active.
[MX-JS9000-SJ,ZN]AH68-02850E-00ENG.indd 26
NON-STOP MUSIC RELAY Function
The NON-STOP MUSIC RELAY function plays
music continuously without an interval between
tracks/files. If there were two mp3 files, it skips to
the next file's 10 seconds from the start position
when the previous track reaches its 10 seconds
before the end position.
Press the NON-STOP MUSIC RELAY button on
the main unit or NON-STOP RELAY button on
the remote control.
Each time you press this button, the mode
changes as follows:
NON-STOP RELAY ON ; NON-STOP RELAY
| NOTE |
✎ This function is only available during playback
of a CD/USB.
TEMPO Function
Use this to change the TEMPO while music is
playing.
1.
During playback (CD-DA/MP3/WMA), press
the TEMPO button on the remote control or
on the main unit.
2.
Select the desired TEMPO by using the
EFFECT-, + button on the remote control or
VOLUME/SEARCH JOG on the main unit.
| NOTES |
✎ You can set each of the TEMPO functions from
-10 to +10. The initial setting for all functions is 0.
✎ TEMPO Function does not operate in the
Bluetooth, TV SoundConnect, TUNER and
AUX mode.
✎ When you turn TEMPO off, all TEMPO settings
are lost.
26
English
OFF
2015-03-23 오전 11:08:57