Fujitsu ARU9RLF Service Instruction page 63

1-3. Setting the Cooler room temperature correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be selected as shown in the table below.
Setting Description
Standard
Slightly lower control
Lower control
Warmar control
When using floor console installation, change the setting value to "01".
1-4. Setting the Heater room temperature correction
Depending on the installed environment, the room temperature sensor may require a correction.
The settings may be changed as shown in the table below.
Setting Description
Standard
Lower control
Slightly warmer control
Warmer control
When using floor console installation, change the setting value to "01".
1-5. Setting the Auto restart
Enable or disable automatic system restart after a power outage.
Setting Description
Yes
No
Auto restart is an emergency function such as for power failer etc.
Do not start and stop the indoor unit by this function in normal operation.
Be sure to operate by the control unit, or external input device.
( Factory setting)
Function Number
30
( Factory setting)
Function Number Setting Value
31
( Factory setting)
Function Number Setting Value
40
03-02
Setting Value
00
01
02
03
00
01
02
03
00
01