Goldmund Mimesis 16.8 User Manual page 12

NOTE
The Direct format allows sending the input
selected to the "Direct Out" cinch without
attenuation. Only the digital input 1 to 6 and the
analog (2-channel) input can be sent to the
Direct output. When the format "Direct" is
activated, the standards outputs of the Mimesis
16.8 are muted.
2 OPERATING THE MIMESIS 16.8 (Ctd.)
2.2 REMOTE CONTROL (Ctd.)
During the balance adjustment you can activate a pink noise. To activate the pink noise,
press on the "BAL" key and then on the "PINK NOISE" key. A Pink noise will be generated
on each digital audio output. If you press again on the "PINK NOISE" key, the pink noise will
be generated to only one output. Each time you press on the "PINK NOISE" key, the pink
noise will change of output as described below:
All outputs ⇒ Front-Left ⇒ Center ⇒ Front-Right ⇒ Rear-Right ⇒ Rear-Left ⇒ Subwoofer
⇒ All outputs ⇒ ...
Note: After the last key pressed for pink noise, a timer of 20 seconds is activated. At the end
of 20 sec the pink noise is automatically cancelled.
INPUT SOURCE SELECTION
The 1 to 14 keys are selecting the source to listen. Digital inputs are numbered from 1 to 10.
Analog Inputs are numbered from 11 to 14.
OUTPUT AUDIO FORMAT SELECTION
Depending on the capabilities of the sources you have selected to listen, several audio
formats may be accessible for the output.
Each time you press on the "FORMAT" key, you change the audio format of the outputs to
one of bellow if permissible:
- G2 (2.0-channel)
- G6 (5.1-channel)
- Direct
The format selected is shown on the front panel.
GOLDMUND MIMESIS 16.8 - UNIVERSAL ACCOUSTIC PROCESSOR - 11