Remote Control - Goldmund Mimesis 16.8 User Manual

2 OPERATING THE MIMESIS 16.8 (Ctd.)
2.2

REMOTE CONTROL

Your Mimesis 16.8 has a built-in remote control for volume, balance and input selection.
MUTING
The mute circuit is controlled using the remote. To mute or un-mute the Mimesis 16.8 with
the remote, press the "MUTE/STDBY" key briefly.
STANDBY
To put the Mimesis 16.8 in Standby mode, press the "MUTE/STDBY" key continuously until
the Mimesis 16.8 goes to Standby, indicated by the Standby Led on the front panel.
OUTPUT VOLUME ADJUSTMENT
The VOL+ and VOL- are adjusting the global volume.
BALANCE ADJUSTMENTS
To activate the balance control, first, press the "BAL" key on the remote control. Then,
adjust the balance.
Note: Adjustment can be done when the Led on the "BAL" key is lit.
The 4 balance keys (diamond configuration) are controlling the right/left and front/rear
balance directly, maintaining a constant global volume.
The gain of the center or the subwoofer can be adjusted by pressing first the "BAL" key,
then press "center" or "sub" key and then the "VOL +" or "VOL -".
Each balance or gain change displayed on the front panel of the Mimesis 16.8 corresponds
to a step of 0.4dB. The value 50 corresponds to the central balance.
Note: After the last key pressed for balance adjustment, a timer of 10 seconds is activated.
At the end of this 10 sec the balance mode is automatically exit and the Mimesis 16.8 return
to his normal state.
GOLDMUND MIMESIS 16.8 - UNIVERSAL ACCOUSTIC PROCESSOR - 10