HP 27SV User Manual page 11

Preparing the monitor for wall-mounting
1. Check the stability of the wall-mounting fixture.
check that the wall-mounting fixture is adequately installed and secured before
attaching the monitor. Refer to the instructions supplied with the wall-mounting fixture
and check that it is capable of supporting the monitor.
2. Disconnect the power cable and any other cables from the monitor.
3. Place the monitor face down on a flat, protected surface.Slide the base away from
Figure 3-3 Sliding the base away from the monitor
4. Four threaded holes are exposed on the back panel of the monitor. These holes
5. Follow the instructions included with the mounting fixture to ensure that the
6. Attach a swing arm or other mounting fixture.
6
Chapter 3. Setting Up the Monitor
WARNING! To reduce the risk of personal injury or of damage to the equipment,
the bottom of the monitor.
are for screws to attach the swing arm or other mounting fixture to the back of the
monitor.
monitor is safely attached. The four threaded holes that are on the back of the
panel are compliant with the VESA standard for mounting flat-panel monitors.
ENWW