Thread Check Spring - Pfaff 3734-2/01 Instruction Manual

Table of Contents

Advertisement

Adjustment
12.

Thread check spring

04.16
● Move workpiece rack 1 ( screw 2 ) in accordance with requirement 1.
● Turn screw 3 ( screw 4 ) to adjust the strength of the spring.
● Move the slack thread regulator 5 ( screw 6 ) in accordance with requirement 2.
12 - 18
Requirements
1. The motion of the thread check spring 7 must be finished when needle point enters the
material ( spring stroke approx. 7 mm ).
2. When the thread loop is at its largest when going around the hook, the thread check
spring must raise slightly from the workpiece rack 1.
Fig. 12 - 14
Due to technical sewing reasons it may be necessary to deviate from the spring
stroke / spring strength mentioned here.Move the slack thread regulator 5
( screw 6 ) toward the "+" ( = more thread ) or toward the "-" ( = less thread ).
4
5
6
+
1
7
3
-
2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

3734-2/21

Table of Contents