Table of Contents
Advertisement
AUDIO
Each DVD disc has a variety of audio output options. Set the player's
AUDIO options according to the type of audio system you use.
AUDIO
Dolby Digital
DTS
MPEG
Sample Freq.
5.1 Speaker Setup
DRC
DOLBY DIGITAL / DTS / MPEG
BITSTREAM: Select "Bitstream" if you connect the DVD Player's
DIGITAL OUT jack to an amplifier or other equipment with a Dolby
Digital, DTS or MPEG decoder.
PCM (FOR DOLBY DIGITAL / MPEG): Select when connected
to a two-channel digital stereo amplifier. DVDs encoded in Dolby
Digital or MPEG will be automatically downmixed to two-channel
PCM audio.
OFF (FOR DTS): If you select "Off", the DTS signal is not output
through the DIGITAL OUT jack.
SAMPLE FREQ. (FREQUENCY)
If your receiver or amplifier is NOT capable of handling 96 kHz
signals, select 48 kHz. When this choice is made, this unit
automatically converts any 96 kHz signals to 48 kHz so your system
can decode them.
If your receiver or amplifier is capable of handling 96 kHz signals,
select 96 kHz. When this choice is made, this unit passes each type
of signal through without any further processing.
Check the documentation for your amplifier to verify its capabilities.
5.1 SPEAKER SETUP
DVD-V
Select speaker settings, including volume balance and distance, or
test the speaker settings.
Speaker settings are only active on the Analog Multi- Channel
Output. (See "Speaker Settings", page 29.)
Bitstream
Bitstream
PCM
48 kHz
Select
On
Move
Select
DVD-V
DVD-A
DivX
DVD-V
DVD-A
DVD-A
DivX
Installation and Setup
DYNAMIC RANGE CONTROL (DRC)
DVD-V
DVD-A
DivX
With the DVD format, you can hear a program's soundtrack in the
most accurate and realistic presentation possible, thanks to digital
audio technology. However, you may wish to compress the dynamic
range of the audio output (the difference between the loudest
sounds and the quietest ones). This allows you to listen to a movie at
a lower volume without losing clarity of sound. Set DRC to On for this
effect.
BEFORE OPERATION
15
Advertisement
Table of Contents
