Saw Chain Tension Adjustment - Echo PowerPruner PPT-266/H Operator's Manual

Hide thumbs Also See for PowerPruner PPT-266/H:
Table of Contents

Advertisement

ASSEMBLY
1. Loosen the two (2) screws (A) and remove locator screw (B)
on cutting attachment.
2. Loosen clamp knob (E) turning counterclockwise.
3. Pull upper tube (F) out of fiberglass lower tube 127-152 mm
(5-6 in.), then slide (F) back into fiberglass lower tube
exposing inner drive shaft (G). Align and join star shaped
drive end of inner drive shaft (G) with cutting attachment
shaft (H).
4. Align ridges (J) on upper tube with seams in cutting
attachment.
5. Slide together, aligning locator hole (D) in cutting
attachment with locating hole (I) in upper tube.
6. Install and tighten locator screw (D). Tighten two (2) cutting
attachment screws (C).
7. Extend upper tube to desired length. Tighten clamp knob (E)
turning clockwise.

Saw Chain Tension Adjustment

Always disconnect spark plug wire before servicing cutting
attachment. Wear gloves when handling saw chain,
otherwise serious personal injury may result.
To Adjust Saw Chain Tension
1. Move stop switch to STOP position.
2. Disconnect spark plug lead.
18
PPT-266/H
F
E
G
J
G
D
B
A
© 10/2014 ECHO Inc.
A
B
H
I
C
X7712091200

Advertisement

Table of Contents
loading

Table of Contents