Table of Contents
Advertisement
Identification of Controls
REAR PANEL (EUROPEAN VERSION)
MIXED
AUDIO OUT
L
DIGITAL OUT
OPTICAL
COAXIAL
R
1
2
3
1 DIGITAL OUT COAX Jack
2 DIGITAL OUT OPTICAL (With Dust Protection Cap) Jack
3 MIXED AUDIO OUT (L & R) Jacks
4 S-VIDEO OUT Jack
5 Composite VIDEO OUT Jack
6 COMPONENT VIDEO OUT Jacks
NOTE
Remove the dust protection cap from the connector and connect the optical digital cable (not supplied) firmly so that the configurations of both
the cable and the connector match. Keep the dust protection cap and always reattach the cap when not using the connector to protect against
dust.
NOTE
The 12V TRIGGER IN jack is a 3.5mm monotype miniature phone jack with the centre pin the 12V signal-sense. We recommend that you use a
good quality cable with shield when attaching the 3.5mm monotype plug so as to prevent false triggering of the amplifier due to electro-magnetic
interference from nearby electronic equipment. The 12V-IN TRIGGER allows you to have an external 12V signal to turn ON the NAD S570 from
standby. This 12V signal must be a continuous 12V signal in order to keep the S570 in the ON state. Once you remove the 12V signal the S570
will return to standby. Check the specifications of the trigger input terminal the other components to ensure these are compatible with the S570.
All 12V-TRIGGER inputs and outputs on other NAD components with a 12V-TRIGGER feature are fully compatible with the NAD S570's 12V-
TRIGGER IN. Before making any connections to any 12V-TRIGGER IN make sure all components are disconnected from the AC mains. If in doubt
over the connections, installation and/or operation of the 12V-TRIGGER IN connection, consult your NAD dealer or sales representative. Failure to
observe the above may result in damage to the NAD S570 and/or any ancillary components attached to it.
NOTE
The EXT. IR IN jack is connected to the output of an IR (infrared) repeater (Xantech or similar), or the IR output of another component to allow
control of the S570 from a remote location. Ask your dealer or custom installer for further details
6
COMPONENT
VIDEO OUT
Y
VIDEO
Cb/
OUTPUT
Pb
SCART/RGB
OUT
VIDEO OUT
S VIDEO
Cr/
Pr
8
6
7
4
5
+12V TRIGGER IN
EXT. IR IN
AUTO
TRIGGER
ON
OFF
9
10
11
7 VIDEO OUTPUT S-VIDEO-SCART/RGB Switch
8 SCART/RGB OUT Jack
9 12V TRIGGER IN jack
10 AUTO TRIGGER ON-OFF Switch
11 EXT. IR IN Jack
12 Power cord socket
AC IN
12
Advertisement
Table of Contents
