Troubleshooting - NAD S 570 Owner's Manual

Reference

TROUBLESHOOTING

SYMPTOMS AND CORRECTION
Check the following guide for the possible cause of a problem before contacting service.
SYMPTOM
No power
The power is on, but the DVD player does
not work
No picture
No sound
The playback picture is poor
The DVD player does not start playback
The remote control does not work
properly
30
CAUSE
• The power cord is disconnected
• No disc is inserted.
• The TV is not set to receive DVD signal
output.
• The video cable is not connected securely.
• The connected TV power is turned off.
• The equipment connected with the audio
cable is not set to receive DVD signal
output.
• The audio cables are not connected
securely.
• The power of the equipment connected
with the audio cable is turned off.
• The Audio output settings are incorrect.
• The disc is dirty.
• No disc is inserted.
• An unplayable disc is inserted.
• The disc is placed upside down.
• The disc is not placed within the guide.
• The disc is dirty.
• A menu is on the TV screen.
• The remote control is not pointed at the
remote sensor of the DVD player.
• The remote control is too far from the
DVD player.
• There is an obstacle in the path of the
remote control and the DVD player.
• The batteries in the remote control are
exhausted.
CORRECTION
• Plug the power cord into the wall outlet
securely.
• Insert a disc (Check that the DVD or VCD
indicator in the S570's display is lit).
• Select the appropriate video input mode
on the TV so that the picture from the
DVD player appears on the TV screen.
• Connect the video cable into the jacks
securely.
• Turn on the TV.
• Select the correct input mode of the audio
receiver so you can listen to the sound
from the DVD player.
• Connect the audio cable into the jacks
securely.
• Turn on the equipment connected with the
audio cable.
• Select either Analogue On or Analogue Off
depending on your hardware
configuration.
• Clean the disc.
• Insert a disc (Check that the DVD or VCD
indicator in the S570's display is lit).
• Insert a playable disc (Check the disc type,
color system and Regional code).
• Place the disc with the playback side
down.
• Place the disc on the disc tray correctly
inside the guide.
• Clean the disc.
• Press the SETUP button to turn off the
menu screen.
• Point the remote control at the remote
sensor of the DVD player.
• Operate the remote control within about
23 ft (7 m).
• Remove the obstacle.
• Replace the batteries with new ones.