Connections; Connecting To A Tv - NAD T550DVD Owner's Manual

PAGE 14

CONNECTIONS

Connecting to a TV

Connect the DVD player to your TV
If the player is connected to the TV through a video cassette recorder, the picture may not be played
back normally with some DVDs. So we strongly recommended you not to connect the DVD player to
your video cassette recorder when setting up your home entertainment system.
To view pictures from the video cassette recorder, set the player to the standby mode.
To S-VIDEO OUT
If the TV has an S-Video
Input, connect the DVD
player with the S-Video
cable (not supplied). It is
not necessary to connect
Video input jack (yellow)
jack.
Notes
Refer to the owner's manual of your TV as well.
When you connect the DVD player to your TV, be sure to turn off the power and unplug both units from the wall
outlet before making any connections.
If your television set has one audio input, connect the DVD player to a Y cable adapter (not supplied) and then
connect to your TV.
Connect the DVD player to your TV directly. If you connect the DVD player to a VCR, the playback picture will
be distorted because DVD video discs are copy protected.
Change the setting of speaker output in Initial Setup, from Multi-channel to Two channel. (Refer to page 34)
The North American version is also equipped with Component Video Out sockets. Connect these if your TV
has Component Video In sockets. Make sure that the TV also uses the Y-Cb-Cr Component Video system.
Make sure to connect all three sockets to the matching sockets on the TV.
Do not connect the T550 to the SCART input and COMPOSITE VIDEO input of the TV at the same time.
(yellow)
R
(red)
To VIDEO
OUT
or
To AUDIO INPUT
To VIDEO INPUT
To SCART OUT or
COMPONENT OUT (YCbCr)
To S-VIDEO INPUT
L
(white)
To AUDIO OUT
(white)
(red)
(yellow)
TV or monitor with
audio video Inputs