Table of Contents
Advertisement
RIGHT
OUTSIDE
LEFT
OUTSIDE
FRONT BRAKE MASTER CYLINDER
[Page: 11, 12 Paragraph: 1]
Install the front brake master cylinder onto the handle-
bars.
Align the dot mark on the handlebars with the master
cylinder-to-holder fitting surface.
Tighten the front brake master cylinder mounting bolts
to the specified torque.
Front brake master cylinder mounting bolt:
NOTE:
To install the holder correctly, first tighten the
bolt C of the upper side with specified torque
and then tighten the bolt D of the lower side.
A: Holder
B: Front brake master cylinder
C: 6 × 22 mm flange bolt
D: 6 × 22 mm flange bolt
E: Dot mark
LEFT SWITCH [Page: 11, 12 Paragraph: 4]
Insert the boss of the left switch holder into the hole on
the handlebars.
Tighten the left switch assembly with the two screws.
Be careful not to pinch the wiring harness
between the housing and holder.
A: Boss
B: Hole
C: 5 × 25 mm screw
D: 5 × 40 mm screw
CLAMP [Page: 13, 14 Paragraph: 4]
Clamp the wiring harness of handlebar right and left
switch with straps.
NOTE:
Cut off the excess strap as shown in the photo-
graph.
A: Strap L:140 mm
B: Handlebars
C: Right switch wiring harness
D: Left switch wiring harness
MOTORCYCLE
Jul. 27, 2007
DATE:
3
14
PAGE:
OF
10 N·m (1.0 kgf-m)
Hide quick links:
Advertisement
Table of Contents
