Antenna Pod Mounting / Harness Routing - Subaru H001SSG400 Installation Instructions Manual

Remote engine start system
Table of Contents

Advertisement

Available languages

Available languages

WINDSHIELD MOUNT ANTENNA INSTALLATION -
5
NON EYESIGHT EQUIPPED VEHICLES, continued

ANTENNA POD MOUNTING / HARNESS ROUTING

1. Plug the 5-pin connector on the antenna harness into the 5-
pin port on the antenna pod. (FIGURE L)
2. Using the supplied long adhesive backed foam tape, carefully
apply the foam tape to one side of the antenna harness
starting 76mm (3") away from the antenna side connector
down the the length of the antenna harness. Carefully fold
the foam tape over and apply to the other side sandwiching
the antenna harness between the foam tape. (FIGURE L)
3. Clean glass surface near antenna mounting area with
alcohol. Remove the adhesive backing on the antenna pod
and apply the antenna to the windshield. The base of the
antenna pod (harness connection end) should line up to the
area of the windshield where the solid black film and dotted
black film meet and 25mm (1") left of the windshield center
mark. (FIGURE M)
4. Route the antenna harness across the headliner and down
the A-pillar tucking the cable below the driver's side
dashboard through the opening closest to the windshield
and allow the harness to hang loose behind the vehicle's
dashboard mounted fusebox. (FIGURE N) The antenna
harness will be plugged into the remote start control module
later.
5. Secure the antenna harness to the existing vehicle wiring in
the A-pillar in six (6) places using the supplied 8" tie wraps.
Wrap the tie wraps with the supplied foam tape to prevent
rattling. (FIGURE O)
6. Using one of the supplied 8" tie wraps, secure the antenna
harness to the vehicle wiring behind the fusebox.
7. Re-install the airbag tether clip to the A pillar panel and
rotate the panel into place.
8. Re-install the A pillar panel and driver's side dashboard tweeter
cover.
9. Re-install the overhead console.
PROCEED TO SECTION 7
PART NUMBER
ISSUE
H001SSG400
DATE
00
27 May 2013
76mm (3")
FIGURE L
Clean mounting
area with alcohol
FIGURE M
FIGURE O
SUBARU OF AMERICA
FIGURE N
4 OF 12

Advertisement

Table of Contents
loading

Table of Contents