Loading Code-Libraries - NAD L 70 Owner's Manual

LOADING CODE-LIBRARIES

The HTR L70 can store a different library of default NAD codes for each of its Device Selector "pages." If
the original default library does not control your NAD CD player, tape deck, DVD player, or other
component, follow the procedure below to change the code-library.
Begin by ensuring that the component you wish the HTR L70 to control is plugged in and powered-up
("on," not merely in standby). To enter the HTR L70's Library Mode, simultaneously press-and-hold for 3
seconds both the desired Device Selector key and the "PROGRAM" key, until the Learn LED turns green.
While keeping the HTR L70 pointed toward the component, enter the first appropriate three-digit code-
library number from the table below. If the component turns off, press "ENTER" to accept that code-
library number and exit the Library Mode. If the component does not turn off, enter the next three-digit
code-library number from the table. When you enter the correct number the component will turn off;
press "ENTER" to accept that code-library number and exit the Library Mode.
NAD-brand component
CD Player (new)
CD Player (old)
DVD T562
DVD T550, L55
DVD T531, T571
DVD T512, T532, T572
SEARCH MODE
If none of the codes from the table turn off the component, and if you are quite sure you have followed
the above procedure completely and carefully, you may want to try the "search" method as follows:
Enter Library Mode by simultaneously pressing-and-holding for 3 seconds both the desired Device Selector
key and the "PROGRAM" key, until the Learn LED turns green. Now press-and-hold the HTR L70's
or key; the remote will step through all the available codes at a rate of approximately 1 per second.
When the component turns off, immediately release the cursor key; press "ENTER" to accept that code-
library and exit the Library Mode. Try a few commands; should you prove to have stepped past the needed
code-library, re-enter the Library Mode and use the cursor key to step back to it.
NOTE
It is possible that search mode will find code-libraries that operate, at least partially, some other-brand
(non-NAD) components. You may certainly exploit such capabilities as you find them. However, since
we can only ensure the completeness or accuracy of NAD code-libraries, we cannot support the HTR
L70's operation with other-brand components.
USING THE HTR L70 REMOTE CONTROL
HTR L70 code-library numbers
200
201
600
601
602
602
Operation
29