Water Supply - Candy GOY 105 TXT User Instructions

) Use the 4 feet to level the machine with the floor:
a) Turn the nut clockwise to release the screw adjuster of the
foot.
b) Rotate foot to raise or lower it until it stands firmly on the
ground.
c) Lock the foot in position by turning the nut anti-clockwise until
it comes up against the bottom of the machine.
The machine has an inlet hose with ¾" threaded ferrules fitted
to the ends to attach between the threaded connector on the
appliance and the cold water supply.
The appliance must be connected to the water mains using n
hose-sets. The old hose-sets should not be reused.
The appliance must only be connected to the cold water supp
Conn ection to a warm water supply, that is over 40°, may dam-
age certain delicate fabrics.
Note: it is advisable to turn off the tap after each wash to
isolate the washing machine from the water supply.
If the inlet hose's connection point is changed, check that the
¾" threaded ferrule on the inlet hose is firmly attached to the
electrovalve connector.
For the washing machine to function properly the terminal end of the discharge
hose (mouth) must be at a minimum of 50 cm and a maximum of 85 cm from the
ground.
48

Water supply

ew
ly.