Iv. Assembly - Pride QUANTUM 1650 Owner's Manual

Seat Installation
The Quantum 1650 seat is attached to the power base by four safety snap pins. Each pin is inserted into a receiver
on the power base frame. The seat towers have holes that enable you to adjust the seat height. Safety snap pins are
inserted through the receiver and through the seat towers to secure the seat.
WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may
lose control of the seat if they do so.
To install the seat:
1. Remove the safety snap pins.
2. Lift the seat over the power base.
3. Align each seat tower with the corresponding seat receiver. See figure 10.
4. Gently allow the seat to slide into each seat receiver until the seat is at the desired height.
5. Insert the safety snap pins into each seat receiver.
6. Install the armrests (if necessary). See figure 11.
7. Loosen the setscrews on the controller mount. See figures 10 and 14.
8. Slide the controller into the controller mount.
9. Tighten the setscrews to secure the controller.
10. Use a wire tie to secure the controller harness to the armrest.
11. Plug the controller harness into the back of the controller and into the connector on the power base.
Figure 10. Seat Installation/Removal (Typical)
Quantum 1650
I V . A S S E M B L Y
SEAT
TOWER
SEAT
RECEIVER
SAFETY
SNAP PIN
www.pridemobility.com
CONTROLLER
MOUNT
POWER BASE
23