Resetting The Grease Filter Timer - Miele DA 6290 D Operating And Installation Instructions

Cleaning and Care
Cleaning the grease filters
^ By hand: use a scrub brush with a
solution of warm water and mild dish
soap.
Do not use the pure detergent,
aggressive all purpose cleaners,
oven sprays, abrasive cleaning
agents or limescale removers. They
could damage the filter.
^ In a dishwasher: place the filter
vertically in the lower basket, making
sure that the spray arm is not
blocked.
Use a wash program with a max.
temperature of 150°F (65°C). In a
Miele dishwasher use the "Normal"
program.
Use the recommended amount of
dishwasher detergent. Overuse could
destroy the filter.
Depending on the detergent,
cleaning the grease filters in a
dishwasher may cause permanent
discoloration of the filter surface.
Filter performance will not be
affected by this discoloration.
^ After cleaning, place the filters on a
towel to air dry.
16
^ While the filters are removed, clean
any dirt or grease from the filter
casing.
^ When putting the grease filters back
make sure that the locking clips are
visibly facing the cooking surface
^ If the filters are incorrectly installed,
insert a small screwdriver into the slit
along its edge to disengage it from
the casing.

Resetting the grease filter timer

After cleaning reset the grease filter
operating hours timer.
^ With the fan running, press and hold
the grease filter button [— for
approx. 3 seconds, until only the 1 is
flashing.
The indicator light [ will go out.
If the grease filters are cleaned before
the timer has reached its maximum:
Press and hold the grease filter button
[— for about 6 seconds, until only the
1 is flashing