HP Ultrium 232e Getting Started Manual page 6

separate terminator.
• If you do not have a VHD, wide SCSI connector on your server, you will need to purchase
and install a VHD-to-HD adapter or use an HD-to-HD cable instead of the supplied cable.
• If you do not have a spare, suitably rated SCSI connector on your server, you must install a
new HBA (also known as a SCSI card). The SCSI bus rating should match or be higher than
the SCSI rating of your tape drive. See Table 2, "supported SCSI bus types," on page 11
for recommended HBAs. For specific details relevant to your server model please refer to
www.hp.com/go/connect . You will need to purchase and install the new HBA into an
unused, 64-bit PCI expansion slot within your server before installing your tape drive. (The
kit can also be installed in a 32-bit PCI expansion slot, but this may limit performance.)
Refer to our World Wide Web site for recommended products, configurations and ordering
information:
4
www.hp.com/go/connect or www.hp.com/support/ultrium .