How To Install The Seat; How To Assemble The Steering Wheel; How To Assemble The Gauge Wheels - Murray 465609x24A Instruction Book

HOW TO INSTALL THE SEAT

Use the fasteners shown below to install the seat. The fasteners are
shown at full size.
1. Carefully remove
plastic bag from the seat.
2. Align the holes in the seat
hinge to the holes in the
seat (Figure 1). Fasten
the seat to the seat hinge
with the fasteners as
shown.
3. Check the operating posi-
tion of the seat. If the seat
needs to be adjusted,
loosen the two wing
bolts. Slide the seat for-
ward or backward along
the seat adjusting holes
as shown. Tighten the
wing bolts (A).

HOW TO ASSEMBLE THE STEERING WHEEL

Use the fasteners shown below to install the steering wheel. The
fasteners are shown at full size.
(A)
25x3
1. Make sure the front wheels point forward.
2. Slide the cover, if equipped, over the steering post (Figure 2).
NOTE: The cover is an optional accessory and is not re-
quired on all models.
3. Slide the steering wheel onto the steering post.
4. Apply firm pressure to center of the steering wheel with the
palm of your hand until you hear a clicking noise. To check for
proper locking of the steering wheel to the steering post, pull
upward on steering wheel.
5. Use the fasteners shown above to secure the steering wheel.
The fasteners are shown at full size. Tighten the screw. DO
NOT over tighten.

HOW TO ASSEMBLE THE GAUGE WHEELS

Use the fasteners shown below to install the gauge wheels.
(A)
31x11
1. Attach the gauge wheels to the axle bolts with the fasteners.
NOTE: The axle bolt is mounted in the LOW position. To change
the position to a higher cutting position, see "How To Adjust
The Gauge Wheels" in the Maintenance section.
F–030758L
the
(C)
17x146
(B)
17x91
ASSEMBLY
(A)
1001054
(B)
17x47
6. Remove adhesive backing from hub cover (found in parts bag)
and place hub cover over hub.
Hub Cover
Steering Post
A
11
Cover
Axle Bolt
B
Seat
Seat Hinge
Seat
Adjusting
Hole
B
A
Figure 1
A
C
Steering Wheel
Figure 2
Gauge Wheel
Figure 3