Sony XEL-1 Operating Instructions Manual page 35

Factory Settings
Analogue Set-up
Programme List
Display
1 Digit Direct
Auto Tuning
Programme Sorting
Programme Block
Intelligent Picture
Manual Programme
Preset
Resets all settings to factory settings except for the "Programme Block" setting,
"Digital Favourite" setting, and programme preset data. After completing this
process, the initial set-up screen is displayed. Completing auto tuning in initial set-
up will reset the settings that are not reset by "Factory Settings". To retain the
settings, select "Cancel" in the auto tuning confirmation dialog.
~
• Do not turn off the TV or press any buttons during "Factory Settings" (takes
about 30 seconds).
Select "Off" to hide the list of analogue channels from the XMB™
(XrossMediaBar).
Select "On" to select a channel using one preset number button (0 – 9) on the
remote.
~
• When "1 Digit Direct" is set to "On", you cannot select channel numbers 10 and
above entering two digits using the remote.
Tunes in all the available analogue channels.
This option allows you to retune the TV after moving house, or to search for new
channels that have been launched by broadcasters.
Changes the order in which the analogue channels are stored on the TV.
1
Press V/v to select the channel you want to move to a new position, then press
.
2
Press V/v to select the new position for your channel, then press
Blocks an individual channel from being watched.
1
Press V/v to select the channel you want to block, then press
2
Press V/v to select "Block", then press
To watch the channel, select "Allow".
On with Indicator Automatically reduces the picture noise. The signal level bar
is displayed when the channel is changed or the display is
changed from an input screen to a TV programme.
On Automatically reduces the picture noise.
Off Turns off the "Intelligent Picture" feature.
Before selecting "Label"/"AFT"/"LNA"/"Audio Filter"/"Skip"/"Colour System",
press PROG +/– to select the programme number with the channel. You cannot
select a programme number that is set to "Skip".
Programme/
Presets programme channels manually.
TV System/ 1
Frequency
2
3
4
5
6
.
Press V/v to select "Programme", then press
Press V/v to select the programme number you want to
manually tune (if tuning a VCR, select programme 0),
then press .
Press V/v to select "TV System", then press
Press V/v to select the best received TV broadcast
systems, then press .
Press V/v to select "Frequency", then press
Press B/b to search for the next available channel. The
frequency band ("VHF Low", "VHF High" or "UHF")
is changed accordingly.
.
.
.
.
.
35
(Continued)
GB