1-3-5. Front Case Assembly and IR Sensor Board
Front case assembly
1-3-6. Fan (Exhaust)-1
Lamp door
(Refer to section 1-3-1, steps 2 to 4.)
Caution :
Because the harness has the shape of flat
cross-section, do not insert the harness into the
harness clamp section with excessive force.
Find out the direction in which the harness can
be inserted easily, and then insert the harness.
Harness
No good
Harness clamp section
VPL-ES7
Tapping screw
Logo
Lens cap
Four claws
(Refer to section 1-3-4, steps 2 to 8.)
Lamp connector
assembly
Door detection switch
harness
Good
Lamp assembly
(PAN M3 x 7)
J7
IR sensor board
Sheet
MB bracket
Front case assembly
Power board
(Refer to section 1-3-5.)
Screw
Loosen two screws.
(+PWH 3 x 6)
Lamp box assembly
1-5