Toshiba e-Studio 2040c Imaging Manual page 185

3. Printer-specific Adjustments
• When "Mono" is selected from among the "Color" options and "Auto" (default) is selected from
among the "Halftone" options, "Detail" of the "Halftone" options is applied to text and graphics
(illustrations), and "Smooth" is applied to raster data (images). Therefore, particular attention is
required since the adjustment may have a different impact according to the patterns of the image to
be printed.
After increasing the density, print and check the print image quality.
If further image quality adjustments are still necessary, use the next procedure.
* This adjustment will have an effect only on Black and white mode printing.
PS3 Mac
(3) Enter adjustment mode [05]. Increase the value for code [8118] to perform fine adjustment and increase the
sharpness intensity.
• Adjust the value for [05] code corresponding to the print option to be applied (PDL and Color mode).
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
PDL Color mode
Black and
PS3
White
Subcode Original
0 Text
1 Graphics
2 Image
* Set the value in increments of approximately 5, while checking the printouts until the optimum value is
obtained.
<Note>
This adjustment changes the values set in the MFP. Therefore, it will affect every user who uses
the printer by connecting it to the MFP. After the adjustment, the values changed will be applied
to all printouts for the "Sharpness" option. Carefully perform the adjustment, being aware that
the image quality of all future printouts will be changed, when printing out originals other than
the one that is used for the adjustment.
Precautions after the completion of the adjustment
The adjustment may possibly cause outlined edges, jaggies and variations in gradation. As a result the photo
image may look unnatural. Therefore, carefully perform the adjustment, while checking the printouts.
e-STUDIO2040C/2540C/3040C/3540C/4540C
[05] code Sub code
05-8118 0/1/2
© 2011 TOSHIBA TEC CORPORATION All rights reserved
3 - 58
Recommended Acceptable
value value range
Set a value lager than
0 to 255
128
Default
128