Main Component Replacement Procedures; Replacement Of The Traverse Deck - Panasonic SA-AK18 Service Manual

SA-AK18
7.2.

Main Component Replacement Procedures

7.2.1.

Replacement of the Traverse Deck

Step 1 Follow the procedures in 'Disassembly of the Traverse
Unit' ( Step 1 - Step 4 ).
Step 3 Desolder the 4 legs of the 2 motors and pull out the
Servo P.C.B.
Step 4 Widen the 3 bosses with a flat screwdriver and pull out
the 3 pins. Then remove the Traverse Deck.
Step 5 Remove the flexible cable CN701.
• Removal of the flexible cable. Push the top of the connector
in the direction of the arrow 1, and then pull out the flexible
cable in the direction of the arrow 2.
Note:
Insert a short pin into the flexible cable for traverse unit.
• Installation of the CD servo P.C.B. after replacement
Step 1 Connect the FFC board.
Step 2 Install the CD servo P.C.B. in the traverse deck
assembly.
Note:
Before installing the CD servo P.C.B., move the optical pickup
towards the outer edge from the marking (black triangle).
[Otherwise, the reset detect switch (S701) mounted on the CD
servo P.C.B. may be damaged.]
10