Table of Contents
Advertisement
(2) Disassembly and reassembly of the magazine section (See Fig. 22.)
Nylon Nut M5 [43]
Sleeve [44]
Ribbon Spring [71]
Feeder Plate [72]
Roll Pin D2.5 x 20 [73]
Nail Feeder (A) [74]
(a) Disassembly
Remove the Hex. Socket Hd. Bolt (W/Flange) M5 x 20 [76] with the hex. bar wrench (4 mm) and so that the
entire magazine section can be removed and the Ribbon Spring [71], Nail Feeders (A) [74], (B) [79] and Nail
Rail [78] can be taken out.
Remove the two Machine Screws (W/Washer) M5 x 16 (Black) [77] with the Phillips screwdriver so that the
Magazine [81] and the Magazine Cover [70] can be removed.
Pull out the Roll Pin D2.5 x 20 [73] with the roll pin puller (2.5 mm (.098") dia.) so that Nail Feeder (A) [74],
Nail Feeder (B) [79] and the Pushing Spring [75] can be removed.
(b) Reassembly
Disassembly procedures should be followed in the reverse order. Note the following points:
The Hex. Socket Hd. Bolt (W/Flange) M5 x 20 [76] should be tightened while pressing the Magazine [81] and
the Magazine Cover [70] so that there will be no space between the Magazine [81] and the Blade Guide [38].
Lubricate the Nail Rail [78] and the Ribbon Spring [71] with Hitachi pneumatic tool lubricant to smooth the
movement of Nail Feeders (A) [74] and (B) [79].
Nail Feeder (B) [79]
Pushing Spring [75]
Fig. 22 Disassembly and reassembly of the magazine section
Magazine Cover [70]
Nail Rail [78]
Nail Stopper [80]
--- 29 ---
Machine Screw (W/Washer)
M5 x 16 [77]
Hex. Socket Hd. Bolt
(W/Flange) M5 x 20 [76]
Nylon Nut M5 [43]
Magazine [81]
[Tools required]
Phillips screwdriver
Hex. bar wrench (4 mm)
Roll pin puller (2.5 mm (.098") dia.)
Advertisement
Table of Contents
