Philips DVDR3590H Service Manual page 82

http://www.jdwxzlw.com/?fromuser=华盛维修
EN 82 5. 3139 785 32804
Nucleus Name
Nucleus Number
Description
Technical
Execution Time
User Input
Error
Example
Nucleus Name
Nucleus Number
Description
Technical
Execution Time
User Input
Error
家电维修资料网，免费下载各种维修资料
Firmware Upgrading & Diagnostic Software
DS_HDD_Diagnostics
2105
Shall perform the internal diagnostic tests implemented by the hard disk drive.
- Initialise/start IDE
- Send the diagnostic (ATA) command to the HDD device
Less than 1 second.
None
Number Description
210500 The Diagnostic test on the hard disk drive device succeeded
210501 The initialisation of IDE failed
210501 The hard disk drive failed
210501 The diagnostics ATA command failed
DS:> 2105
210500:
Test OK @
DS_HDD_UploadImage
2106
Upload raw data from the HDD to a DVD+RW
- Initialise/start IDE
- Check for an ATA device on the IDE interface
- Check for an ATAPI DVD+RW drive
- Calibrate the DVD+RW laser
- Repeat until transfer is completed
- Read x MB from HDD source sector into SDRAM
- Write x MB from SDRAM to the destination sector on DVD+RW
- Read sector 0x34000 on DVD containing the transfer table to use
- Update the contents of the table and write it back
Depending on the number of sectors to transfer it may take approximately 2 MB
per second.
The user can enter 3 parameters in the next format:
<COMMAND> <HDD sector> <nr of HDD sectors>
<COMMAND> is one of the next strings:
� NEW: Create a new transfer image table, <HDD sector> and <nr of
HDD sectors> must be entered.
� ADD: Add a section to the current transfer table, <HDD sector> and
<nr of HDD sectors> must be entered
READ: Read the current transfer image table from the DVD. The tray
�
of the DVD drive is sent out an the user is asked to insert a DVD+RW
� VIEW: View the contents of the current transfer table
� GO: Copy data from the HDD to the DVD+RW according to the
currently entered transfer table
<HDD sector> = the sector on HDD to start reading from
<HDD sectors> = the number of HDD sectors to transfer
Number Description
210600 Uploading image succeeded
210601 The initialisation of IDE failed
210602 Communication with the hard disk drive failed
210603 Communication with the AV3 failed
210604 No DVD+RW is available
210605 Calibrating DVD+RW failed
210607 Error while reading image data from HDD
210608 Error while writing image to DVD+RW
210609 Unable to update the transfer table on the DVD+RW