Mazda 3-sport 2016 Manual page 93

NOTE
Function number 3 is the factory setting
for your vehicle.
There are only a total of ve auto lock/
unlock settings available for automatic
transaxle vehicles, and three for manual
transaxle vehicles. Be sure to press the
unlock side of the driver's door-lock
switch the correct number of times
according to the selected function
number. If the switch is mistakenly
pressed six times on an automatic
transaxle vehicle or four times on a
manual transaxle, the procedure will
be cancelled. If this occurs, start the
procedure from the beginning.
Function
number
The auto door-lock function is
1
disabled.
All the doors and the liftgate lock
2 automatically when the vehicle speed
is about 20 km/h (12 mph) or more.
All the doors and the liftgate lock
automatically when the vehicle speed
is about 20 km/h (12 mph) or more.
3
All the doors and the liftgate unlock
when the ignition is switched from
ON to Off.
(Automatic transaxle vehicles only)
When the ignition is switched ON
and the shift lever is shifted from
4
park (P) to any other gear position,
all the doors and the liftgate lock
automatically.
Mazda3_8FA4-EA-15G_Edition2.indb 17 Mazda3_8FA4-EA-15G_Edition2.indb 17
Function
*1
Doors and Locks
Function
Function
number
(Automatic transaxle vehicles only)
When the ignition is switched ON
and the shift lever is shifted from
park (P) to any other gear position,
all the doors and the liftgate lock
5
automatically.
When the shift lever is shifted to park
(P) while the ignition is switched ON,
all the doors and the liftgate unlock
automatically.
*1 Other settings for the auto door lock function are
available at an Authorized Mazda Dealer. For
details consult an Authorized Mazda Dealer. Refer
to Personalization Features on page 9-12 .
Settings can be changed using the
following procedure.
1. Safely park the vehicle. All doors must
remain closed.
2. Switch the ignition ON.
3. Press and hold the lock side of the
driver's door-lock switch within 20
seconds of switching the ignition ON,
and make sure a beep sound is heard
about eight seconds afterwards.
4. Refer to the auto lock/unlock function
setting table, determine the function
number for the desired setting. Press
the unlock side of the driver's door-lock
switch the same number of times as the
selected function number (Ex. If you
select function 2, press the unlock side
of the switch only 2 times).
5. Three seconds after the function setting
has been changed, a beep sound will
beep in the amount of the selected
function number. (Ex. Function number
3 = 3 beep sounds)
Before Driving
*1
3–17
2015/07/16 8:44:02 2015/07/16 8:44:02