Preset Memory Function - Clarion db315 Owner's Manual

Preset Memory Function
Preset Memory Function can store up to 24 sta-
tions: six stations for each of FM1, FM2, FM3
and AM
Note:
• When the present memory function
is
used, all the
content of the memory will be erased
Manual memory function
1) Press the BND button ij1], and select the
band you want to store in the memory
2) Press the SRCH LetVRight button
~
then
select the station you want to store in the
memory
3) Press and hold the Preset button
I1Q]
for 2
seconds or longer, then the station will be
stored in the memory
Auto store function (Automatic Station Store)
1) Press the BND button
ij1],
then select the
band you want to store in the memory
2) Press and hold the AS button [[] for 2 sec-
onds or longer, then the station at which the
reception is the strongest will be automatical-
ly stored in the memory
Note:
• When the number of stations stored is less than six,
the previous content of the memory for each direct
button will be retained
Preset Scanning (Preset Station Scan)
When the PS button [[] is pressed, the preset
memory numbers flash and the stations are
tuned in for 7 seconds each in the order in which
they were stored Press the PS button again to
cancel the preset scanning mode
Instant Station Recall (ISR)
With this function, a specific radio station can be
recalled from any mode
ISR memory
1) Press the FNC button
00,
then select the
radio mode
2) Select the radio station which you want to
store in the memory
12
08315
3) Press and hold the ISR button
lID
for 2 sec-
onds or longer
Recalling ISR
Press the ISR button
lID
then the display will
show "ISR", then the radio station previously
memorized will be selected Press the ISR but-
ton
lID
again to disengage the unit from the
Recalling ISR function
Area Change
Use this function when you are using the car
stereo anywhere outside the U S
Switchable frequency spacing
This car stereo is initially set to tune in frequen-
cy intervals of 10kHz for AM and 200 kHz for
FM, the standard calibrations in the U S When
using the unit outside the US, use the following
procedure to switch the frequency range
The table below lists the frequency specifica-
tions for the U S and other countries
~
Initial Setting New Setting
(U S standard) (outside US)
Frequency
10 kHz 9 kHz
spacing
AM
Frequency 530 to 531 to
range
1,710 kHz 1,629 kHz
Frequency
200 kHz
50 kHz
spacing
FM
Frequency 879 to 875 to
range
1079 MHz 108 MHz
SWitching the area change
Outside U S (New Setting)
While pressing the BND button
ij1],
press the
SRCH Left button
~,
then "outside US" will be
selected
Inside U S standard (Initial Setting)
While pressing the BND button ij1], press the
SRCH Right button
~,
then the "U S standard"
will be selected