Mazda 2002 tribute Manual page 268

Maintenance and Specifications
Fluid Classification
4
Engine coolant Mazda
green-colored or
yellow-colored
Premium Engine
Coolant
Rear axle SAE 80W-90
lubricant Premium Rear
Axle Lubricant
Windshield n/a
washer fluid
1
Ensure the correct automatic transmission fluid is used. Transmission
fluid requirements are indicated on the dipstick or on the dipstick
handle. MERCON and MERCON V are not interchangeable. DO NOT
mix MERCON and MERCON V. Refer to your scheduled maintenance
section to determine the correct service interval.
2
Service refill capacity is determined by filling the transmission to the
bottom of the filler hole with the vehicle on a level surface.
3
Indicates only approximate dry-fill capacity. Some applications may vary
based on cooler size and if equipped with an in-tank cooler. The amount
of transmission fluid and fluid level should be set by the indication on
the dipstick's normal operating range.
4
Add the coolant type originally equipped in your vehicle. DO NOT USE
Extended Life Engine Coolant (orange in color). Refer to Adding engine
coolant in this chapter.
5
Fill to 6 mm to 14 mm (1/4 inch to 9/16 inch) below bottom of fill hole.
For further information on your lubrication specifications, see your
authorized Mazda dealer.
268
Application Capacity
2.0L I4 Zetec 5.0L (5.3
engine with quarts)
manual
transaxle
3.0L V6 Duratec 10.0L (10.6
engine with quarts)
automatic
transaxle
4X4 1.4L (2.96 pints)
5
All 2.6L (2.7
quarts)