To configure Connection 1 for PPPoE, follow the steps listed below.
Some of the settings do not need to be changed the first time the device
is set up, but can be changed later if you choose.
1. Click the Connection 1 button under WAN Setup to view the
default PPPoA Connection Setup configuration menu.
2. Select PPPoE from the Type: pull-down menu. The menu will
blink momentarily
3. Type in a Name: for the connection or use the default name in
the space provided (WAN_PPPoA used in the above example).
4. Under Options, enable NAT and/or Firewall by selecting the
corresponding selection box.
5. If you are told to change the VPI or VCI values, type in the values
given to you by your service provider. Many users will be able to
use the default settings.
6. Leave the default QoS values if you are unsure or the ISP did not
provide this information.
9