Configure Connection 1 For Pppoa - D-Link DSL-G604T Quick Installation Manual

7. Do not change the PCR or SCR values unless you are required
to do so. If you are told to change these, type in the values given
to you by your service provider.
8. Type the Username and Password used to verify the identity of
your account. Typically, the Username is an account number
assigned by your ISP and appears in the form
account#@serviceprovider.com, while the Password may have
been chosen by the account holder. For most users, the
remaining settings will not need to be changed. See your ISP for
further information.
9. Click the Apply button when you have entered all the information.
The web browser will briefly go blank. You are now finished
changing setting for the primary WAN connection known as
Connection 1. It is now necessary to save the changes you just
made and restart the Router.
10. To save the changes made to Connection 1, click the Tools tab
and then click on the System Commands button. Click on the
Save All button to store the configuration settings. Click on Back
button to return to the System Commands menu.
Check the WAN connection status. Click the Status tab and then the
Connection Status button. Look under WAN to view the State of
Connection 1, it should read Connected. If the WAN connection state
does not appear to Connected after a few minutes, go back to the
Connection 1 Setup menu, check the settings and make sure they are
correct.

Configure Connection 1 for PPPoA

PPP or Point-to-Point protocol is a standard method of establishing a
network connection/session between networked devices. Different forms
of PPP include PPPoA and PPPoE (discussed below) involve an
authentication process that requires a username and password to gain
access to the network. PPPoA (PPP over ATM) as described in RFC
2364, is a method of using PPP on an ATM network. ATM is used for
many types of telecommunications services including ADSL.
To configure the WAN connection for PPPoA, perform the steps listed
below. Some of the settings do not need to be changed the first time the
device is set up, but can be changed later if you choose.
10