Change The Connection Type - D-Link DSL-G604T Quick Installation Manual

7. Type the Username and Password used to verify the identity of
your account. Typically, the Username is an account number
assigned by your ISP and appears in the form
account#@serviceprovider.com, while the Password may have
been chosen by the account holder. For most users, the
remaining settings will not need to be changed. See your ISP for
further information.
8. Click the Apply button when you have entered all the information.
The web browser will briefly go blank. You are now finished
changing setting for the primary WAN connection known as
Connection 1. It is now necessary to save the changes you just
made and restart the Router.
9. To save the changes made to Connection 1, click the Tools tab
and then click on the System Commands button. Click on the
Save All button to store the configuration settings. Click on Back
button to return to the System Commands menu.
10. Check the WAN connection status. Click the Status tab and then
the Connection Status button. Look under WAN to view the
State of Connection 1, it should read Connected. If the WAN
connection state does not appear to Connected after a few
minutes, go back to the Connection 1 Setup menu, check the
settings and make sure they are correct.

Change the Connection Type

The default connection protocol used for the Router is Point-to-Point
Protocol over ATM (PPPoA). The menu used to configure a PPPoA
connection is the first menu to appear when you click on the Connection
1 button in the Setup menu. The alternative connection types supported
by the Router are the PPPoE (PPP over Ethernet), CLIP (Classical IP
over ATM or IPoA), DHCP (for WAN), Static (IP for WAN), and Bridge
connection types. There are two ways you may configure the WAN
connection to use these alternative types. You can create a New
Connection using the alternative connection type or you may configure
the Connection 1 settings to use the connection type of choice.
12