AKG DMM14 U Reference Manual page 77

Description
Front controls
Rotary knobs for
inputs
LED ON
LED PEAK
DMM14 MANUAL
5.3 Front: Description of the controls
There is a total of nine controls on the front.
8 8
IN 2 / USB R IN 4 / DANTE 2
EQ 350 Hz EQ 700 Hz
8 8
ON PEAK ON PEAK
IN 1 / USB L IN 3 / DANTE 1 IN 5 / DANTE 3
EQ 250 Hz EQ 500 Hz EQ 1.0 kHz
ON PEAK ON PEAK
1 2 3 4
Figure 1: Front of the DMM14 U (UL, ULD)
The following table describes the controls on the front of the
DMM14 U (UL, ULD):
No. Description
1 to 12 Microphone or line inputs
13 Operating mode / SYSTEM CONTROL
14, 16 Stereo outputs 1 and 2
15, 17 Modulation display for stereo outputs 1 and 2
18 Stereo headphone output
19 Socket for headphone connection
The parameters of the selected audio functions are changed using the
controls.
5.3.1 Controls for input channels
The DMM14 U (UL, ULD) has 12 balanced input channels to connect low
ohm, dynamic microphones or capacitor microphones and other signal
sources, e.g. receivers for wireless microphones. There is a control for each
input channel (1 to 12).
Each input channel has a green LED ON and a red LED PEAK.
ON is lit when the input channel is prioritized in automatic mode. If the
Automix function is switched off, ON is lit continuously.
PEAK is lit if the signal on an input channel comes close to the maximum
modulation limit. In this case, the level should be reduced or the input sensi-
tivity changed.
8 8 8 8
IN 6 / DANTE 4 IN 8 IN 10
EQ 1.4 kHz EQ 2.8 kHz EQ 5.6 kHz
8 8 8
ON PEAK ON PEAK ON PEAK ON PEAK
IN 7 IN 9 IN 11
EQ 2.0 kHz EQ 4.0 kHz EQ 8.0 kHz
ON PEAK ON PEAK ON PEAK
5 6 7 8 9 10 11
8 8
PRIORITY
AUTOMIXING PAN / BALANCE
IN 12
COMPRESSOR DELAY
EQ 11.3 kHz
LIMITER ROUTE TO REC
8
LOW CUT ROUTE TO USB
BASS EQUALIZER
TREBLE PRESET
OUT 1 OUT 2 HEADPHONE
LEVEL
L L
LOCKED IN USB / DANTE
-50 -40 -30 -20 -10 -5 0 +5 dB -50 -40 -30 -20 -10 -5 0 +5 dB
R R
SYSTEM CONTROL
ON PEAK
12 13 14 15 16 17 18
8
19
77