Advertisement
Output Connections
The following output ports are available at the DSR-6402 rear panel:
GIGE:
If Gig-E functionality is used, it must be enabled via the TS option from the front panel
IP menu. Depending on the configuration of the TS option (Off, Transcoded, Passthru,
or Transcoded+Passthru) the GIGE port may carry one or more transport streams. When
Passthru is selected, a copy of the ASI OUT 1 transport stream is routed to the GigE port.
When Transcoded is selected, a copy of the ASI OUT 2 transport stream is routed to the
GigE port. When Transcoded+Passthru is selected, a copy of both ASI OUT 1 and ASI OUT
2 are routed to the GigE port.
ASI OUT 1:
The ASI OUT 1 is the "Passthru" port. This port delivers MPEG4 video without transcoding
or other processing.
ASI OUT 2:
The ASI OUT 2 is the "Transcoded" port. This port delivers MPEG2 compressed video.
The transcoded output can carry HD, SD, or a combination of the two. For the Discovery
services, only the HD stream is used.
VIDEO OUT:
Primarily used for analog SD-only output; also used with analog audio terminals.
OSD VIDEO OUT: Confidence Video monitor (plus Fast Facts and Diagnostic video overlays of live video). This
SD output is not intended for live use, and has no closed-caption support.
Installation/Initial Configuration
With power applied to the DSR-6402, the splash screen with the device name and version number will briefly
appear, followed by the main menu as shown. DSR-6402 menu items that are selectable and/or configurable
are identified by the right-pointing arrow adjacent to the item. Items without the arrow are read-only.
Motorola DSR-6402
Version 0xXXXXX
In Case of Code Download
The DSR-6400 Series support background code download over satellite. If a newer version of firmware
becomes available, the unit automatically begins downloading and storing the new code at signal lock.Should
this occur, the front-panel Download LED will blink during download and turn solid green when the download
completes. When download is complete your unit will automatically reboot and load the new code on restart.
Gig-E Port Enable
If you intend to use the Gig-E output port, it must first be enabled via the front-panel IP menu. If you do not
use the Gig-E output port, then skip this section and got to Manual Tune Setup, below.
1. Use the front-panel left
2. You can then use the up
3. Press
and
to select TS Mode, then press Enter.
4. Use the and keys to scroll to the desired
Transport Stream Mode (Off, Transcoded, Passthru, or
Transcoded+Passthru), then press Enter.
5. Press to move the cursor to the home position for this menu, then press Enter. The Main Menu
displays.
Note that full configuration of the Gig-E port requires provision of an IP address, subnet mask, and
gateway address, available from your System Administrator. For more information, see the DSR-6400
Series Operator Guide.
and right
navigation keys to select the IP option, then press Enter.
and down
navigation keys to scroll to the Port GigE –> TS Mode display.
t u
E
Install
Channel
PORT GigE
p
E
t u
q
2
DSR-6402
Status
IP
TS Mode
Passthru
Diag
DSMCC
Off
Advertisement
