Page 1
Compliance and Copyright DL100 , DL200 Letter Opener ™ ™ Safety Notes Setting Up the DL100 or DL200 Meet the DL100 or DL200 Using the Setup Menu (DL200 Only) Opening Envelopes Maintaining your DL100 or DL200 Troubleshooting Operator Guide Specifications...
Page 2
Except as provided in writing, duly signed by an officer of Pitney Bowes, no license, either express or implied, under any Pitney Bowes or any third party’s patent, copyright, or other intellectual property rights is granted by providing this information.
• Use only Pitney Bowes approved supplies, in particular aerosol dusters. Improper storage and use of aerosol dusters or flammable aerosol dusters, can cause an explosive-like condition that could result in a personal injury and/or property damage. Never use aerosol dusters labeled flammable and always read instructions and safety precautions on the duster container label.
Page 4
← Back to Main Setting Up the DL100 or DL200 Letter Opener IMPORTANT: Please review the Safety Notes before setting up the DL100 or DL200.
Parts and Locations The DL100 or DL200 Letter Opener automatically opens a stack of envelopes by cutting a thin paper strip off of the top of each envelope. The DL100 or DL200 then stacks the envelopes, and separates the paper strips into the waste area on the stacker tray.
Page 6
← Back to Main Meet the DL100 or DL200 Letter Opener Power Button Light States Cut Depth Adjustment Knob Settings z z z No Light: Sleep Mode (Press button to awake) Cut Thin Pieces Cut Thick Pieces Green Light: Ready (Press button to sleep)
Page 7
← Back to Main Using the Setup Menu (DL200 Only) 1. Press the power button to put the letter opener in sleep mode (no light). 2. Press any of the display buttons to enter the Setup menu. 3. Press the right and left arrow buttons to scroll through the available menu options. 4.
Page 8
← Back to Main Opening Envelopes Follow the steps below to set up and open envelopes. 1. Turn the cut depth adjustment knob to the desired setting: to cut a thin piece, cut a thick piece, or count pieces (DL200 only). IMPORTANT: Select this option carefully, to avoid cutting the contents of the envelope.
Page 9
← Back to Main Maintaining the DL100 or DL200 Cleaning the Waste Area Cleaning the Sensors Remove paper strips from the waste area after opening a stack of Wipe the feed sensor and exit sensor windows with a damp cloth on a envelopes, as a large accumulation of paper strips can interfere with regular basis.
z z z ← Back to Main Troubleshooting Clearing a Jam Poor operation or jams will occur if paper strips are allowed to accumulate, if the cut depth adjustment knob is turned while envelopes are processing, or if an attempt is made to feed an envelope that falls outside of the specifications mentioned. The flashing red power button light state indicates that a jam has occurred.
33.07 lbs. (15 kg) Electrical 100-240 VAC, 50/60 Hz Acoustical Noise <73 dBA Throughput DL100: Up to 150 letters per minute DL200: Up to 250 letters per minute 5 years or 500,000 cycles Product Life Environmental Limits Operating Limits - °F (°C)
Page 12
← Back to Main Getting Help USA Contacts Product Name - DL100, DL200 • For frequently asked questions, go to: www.pb.com and click on Customer Support. • To place requests for service or training, go to: www.pb.com and click on My Account.