Table of Contents
Advertisement
&En
n = 0–15
$En
n = 0 or 1
$EBn
n = 0 or 1
%En
n = 0–5
&Fn
n = 0, 8, or 9
$Fn
n = 0 or 1
%Fn
n = 0 or 1
V.42 Error Correction Modes
&E0
Non-error correction mode (V.42 disabled).
*** &E1
Auto-reliable mode.
&E2
Reliable mode (V.42 enabled).
Modem-Initiated Flow Control
&E3
Flow control disabled.
*** &E4
Hardware flow control.
&E5
XON/XOFF flow control.
XON/XOFF Pass-Through ( &E5 selected)
*** &E6
XON/XOFF not passed through.
&E7
XON/XOFF passed through.
Hewlett-Packard ENQ/ACK Pacing
*** &E8
ENQ/ACK pacing off.
&E9
ENQ/ACK pacing on.
Non-Error Correction Mode Flow Control
*** &E10 Non-error correction mode flow control off.
&E11 Non-error correction mode flow control on.
Pacing (Computer-Initiated Flow Control)
&E12 Pacing off.
*** &E13 Pacing on.
Data Compression
&E14 Data compression disabled.
*** &E15 Data compression enabled.
V.42 Error Correction at 300 bps
*** $E0
V.42 error correction at 300 bps disabled.
$E1
V.42 error correction at 300 bps enabled.
Asynchronous Word Length
*** $EB0 10-bit mode enabled.
$EB1 11-bit mode enabled.
Escape Sequence Options
%E0
Modem won't escape.
*** %E1
+++ method.
%E2
Break method.
%E3
Either +++ or break methods.
*** %E4
No OK response to +++.
%E5
OK response to +++.
Load Default Configuration
&F0
Load factory default values from ROM.
*** &F8
Read factory default values and DIP switch settings when &F is issued.
&F9
Read parameters stored in nonvolatile memory when &F is issued.
Auto-Reliable Fallback Character Enable
*** $F0
Do not fall back to non-error correction mode connect if CR received.
$F1
Fall back to non-error correction mode connect if CR received.
Echo Canceler Offset Frequency Compensation
*** %F0
Disable echo canceler offset frequency compensation.
%F1
Enable echo canceler offset frequency compensation.
Appendix
100
Advertisement
Table of Contents
